Walkthrough for 9front-ANTS on Vultr from source with standard 9front image
Walkthrough done with 1gb ram image size
Create a Vultr account if you do not have one, and upload a copy of the current 9front iso. A working copy of a 9front release iso (revision 6245 from December 2017) can be found at http://files.9gridchan.org/9front6245.iso. Choose to enable a private ip. Make sure the size (smallest is good) and location are correct, and that the 9front iso is attached. Deploy!
Manage the vm and install through the graphical console interface
The general method of installation is covered in the 9front.org fqa. Hit enter a few times until the rio gui starts. You can use the live cd and begin the install with inst/start when ready. You will be choosing to use hjfs instead of the default cwfs. You have the option to do a minimal ANTS install with hjfs only, or to add fossil and venti also. To do so, we will make the hjfs partition small during the install process. Here are the relevant inputs, with everything else being left as default:
inst/start hjfs #configfs sdF0 #partdisk mbr w q d fs #prepdisk a fs 204801 4400000 w q # press enter a lot until copydist and you wait for a few minutes # set timezone and system name and then say yes # to the questions to make plan 9 mbr active yes
converting base install to Advanced Namespace Tools
Remove the iso from the virtual machine, reboot the fresh install, and clone the ANTS repo:
hg clone https://bitbucket.org/mycroftiv/plan9ants cd plan9ants
You probably want to set the rio window to 'scroll' mode. Now we will install ANTS. The command depends on whether you chose to make a small hjfs partition to allow room for fossil+venti, or will be using hjfs only. For a fossil+venti full ANTS system (requires the special partitioning during install shown above):
If you are leaving hjfs as your sole filesystem, then instead enter:
Once the installs are completed (the vultrfossil script runs for a long time as it is making another full copy of the distribution into the new fossil) you can fshalt -r to reboot with ANTS installed.
using the ANTS environment
In addition to standard Plan 9, the ANTS namespace and tools are available. You can rcpu or drawterm in to the boot namespace on port 17060. To move into the main environment from there:
rerootwin -f boot service=con . $home/lib/profile webfs
You can also access the early namespace by attaching hub to /srv/hubfs. It can be convenient to rimport the early namespace rcpu/exportfs listener (port 17060) from another machine also.